International Journal of Advances in Mechanical and Civil Engineering (IJAMCE)
.
Follow Us On :
current issues
Volume-9,Issue-4  ( Aug, 2022 )
Past issues
  1. Volume-9,Issue-4  ( Aug, 2022 )
  2. Volume-9,Issue-3  ( Jun, 2022 )
  3. Volume-9,Issue-2  ( Apr, 2022 )
  4. Volume-9,Issue-1  ( Feb, 2022 )
  5. Volume-8,Issue-6  ( Dec, 2021 )
  6. Volume-8,Issue-5  ( Oct, 2021 )
  7. Volume-8,Issue-4  ( Aug, 2021 )
  8. Volume-8,Issue-3  ( Jun, 2021 )
  9. Volume-8,Issue-2  ( Apr, 2021 )
  10. Volume-8,Issue-1  ( Feb, 2021 )

Statistics report
Dec. 2022
Submitted Papers : 80
Accepted Papers : 10
Rejected Papers : 70
Acc. Perc : 12%
Issue Published : 49
Paper Published : 1001
No. of Authors : 2679
  Journal Paper


Paper Title :
Adhesive Wear Behavior Of Tin And Crncoated Din115crv3 Steel Tools At Different Load Conditions

Author :Mustafa Ozgur Oteyaka, Muhammetmustafa Yildirim, Mustafa Ulutan, Osmannuri Celik

Article Citation :Mustafa Ozgur Oteyaka ,Muhammetmustafa Yildirim ,Mustafa Ulutan ,Osmannuri Celik , (2015 ) " Adhesive Wear Behavior Of Tin And Crncoated Din115crv3 Steel Tools At Different Load Conditions " , International Journal of Advances in Mechanical and Civil Engineering (IJAMCE) , pp. 1-4, Volume-2, Issue-5

Abstract : In manufacturing industry, the wear of cutting tools play a major role especially in surface roughness and finish quality of final products. In this study, hardened tool steel DIN 115CrV3 with superior mechanical properties was used as cutting tools. A physical vapor deposition (PVD) technique was performed for coating TiN and CrN on steels heat treated at 780°C. The adhesive wear experiments were performed at progressive and constant loads and then they were quantified and compared to hardened steel. Results of adhesive wear under progressive load showed lower friction of coefficient and friction force compared to ceramic coatings. The internal stress of hardened steel was found higher relative to TiN- and CrNcoated tools. The measurement of critical load of adhesion and delamination failure showed that CrN coating had better resistance than TiN coating. The hardened steel tools performed the worst adhesive wear at constant load compared to ceramic coatings. TiN-coated tools had better coefficient of friction values and adhesive wear properties at constant load than the others. Microstructure analysis of worn samples were used for characterization of wear properties of the samples. Keywords- Adhesive Wear, Physical Vapor Deposition, Coating, Delamination.

Type : Research paper

Published : Volume-2, Issue-5


DOIONLINE NO - IJAMCE-IRAJ-DOIONLINE-3121   View Here

Copyright: © Institute of Research and Journals

| PDF |
Viewed - 88
| Published on 2015-10-13
   
   
IRAJ Other Journals
IJAMCE updates
IJAMCE vol-8, Iss-2(April 2021)
The Conference World

JOURNAL SUPPORTED BY