Paper Title :Dessection On Machinability Of AISI 1040 Steel
Author :Akshaya T Poojary, Rajesh Nayak
Article Citation :Akshaya T Poojary ,Rajesh Nayak ,
(2014 ) " Dessection On Machinability Of AISI 1040 Steel " ,
International Journal of Advances in Mechanical and Civil Engineering (IJAMCE) ,
pp. 33-39,
Volume-1,Issue-1
Abstract : The reduction of temperature at the cutting zone becomes the dominating factor for determining the reliability or
efficiency effectiveness of a coolant. The conventional cutting fluids fail to achieve the desired cutting temperature and also
have techno-environmental problems along with the possibility of corroding the workpiece and machine tool parts. Cryogenic
coolant (dip in LN2) has the potential to obtain the desired cutting temperature and is also environment friendly. The current
work involves the experimental study for determining the optimized method of machining for AISI 1040 steel under dry, wet
and cryogenic coolant (LN2) conditions by analyzing cutting force, surface roughness and chip formation for all the conditions.
Even though cutting forces obtained for cryogenic cooling were high but surface roughness, chip formation were in favor of
encouraging cryogenic cooling.
Type : Research paper
Published : Volume-1,Issue-1
DOIONLINE NO - IJAMCE-IRAJ-DOIONLINE-1165
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 79 |
| |
Published on 2014-08-14 |
|
